In nearly all situations, most individuals spend quite a bit of money buying their forklift. Therefore, it is really essential to take proper care of it in order to protect your investment well into the long run. It is a great idea to know the procedures which are undertaken in maintaining and taking care of this machine.
By starting up the forklift and listening closely how it runs is amongst the best ways to tell how good the engine is performing. Like for example, if there are any knocks or misses, the equipment is defective and this must raise several concerns. In addition listen closely for any squealing noise which come from the belts since these noises would provide you with a lot of information.
Several of the main components requiring attention during maintenance include the safety warning devices, gauges, horn, the lights and the overhead guard. Any burnt out light bulbs or faulty parts should be replaced as soon as they are noticed. It is also essential to inspect the wiring.
The battery compartment terminals must be cleaned when the above components have been checked carefully. If the terminals are not clean, be sure to clean them well. Each and every cell of the battery must be inspected so as to ensure the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the machine and then change the filters. The transmission filter, fuel filters and the hydraulic filter should be regularly replaced. Before fitting them, be sure to write the date on the new filters by using a permanent marker to be able to keep track.
Once the oil change has been done and new filters have been fitted, visually check the drive axle from beneath the equipment. Be sure to grease the axle if there is any grease fitting. Inspect the belts on the engine for any cracks or frays. If you find any, fix the issue accordingly. Next, check each and every other component of the machine including the wheels. If any kind of concern or fault is detected, be sure to deal with it immediately so as to make sure the machinery is running at its safest and optimum levels.